Learning notes · Planned studies

Build the evidence behind the work.

A roadmap for future CAD, drawings, and simulation work. These are proposed exercises and documentation goals, not completed projects or claimed results.

01

SOLIDWORKS · Start here

A drawing package for a real component

Use a wheel hub, servo mount, or small bracket from your own work. Complete the drawing tutorial, then apply the process to your component.

What to produce

A dimensioned part drawing, section/detail views where needed, material and units, an assembly view, and a bill of materials. Explain one fit or tolerance choice based on how the part will be made.

Make it your own

Change a real interface or assembly requirement and show how your drawing and model respond. Attribute the tutorial; distinguish your design decisions from the exercise.

02

ANSYS Mechanical · Build the fundamentals

A verified structural study

Start with a cantilever beam to understand constraints, loading, and the limits of beam theory. Then apply the workflow to a mounting bracket of your own design.

What to produce

Geometry, material properties, load justification, boundary-condition images, a mesh-refinement table, displacement and stress plots with units, and a hand-calculation comparison. Discuss stress concentrations and singularities.

Make it your own

Compare two bracket designs at the same load. Report mass and displacement changes; justify any stress or safety-factor comparison. Label this as a simulation study unless physical testing has also been completed.

03

SO-101 · Connect CAD to hardware

A robot modification with a measured result

Use the official SO-101 assembly and calibration documentation, then develop a small original improvement such as a camera mount, cable guide, or gripper accessory.

What to produce

An assembly photo, a drawing of your new part, a short teleoperation video, and a repeatable test with a stated number of trials. Record the conditions and failures as well as successful runs.

Make it your own

Compare the original and modified setup on the same task. Show why the change helps, and separate your contribution from the open-source robot design.

A stronger case study, one project at a time.

Lead with the problem and constraints. State your individual role, show two alternatives, explain the choice, and present the evidence. Finish with limitations and what you would change next.

  • Use your own screenshots, drawings, photos, and test data.
  • Include dimensions, units, loads, and readable plot legends.
  • Pair every performance claim with its test method or calculation.
  • Add a short demonstration video and a concise PDF once the work is complete.
  • Keep confidential employer hardware and data out of public examples.

Resources checked November 2026. Software access or an account may be required; menus can vary by version.